+- Lindeni Forum (http://forum.lindeni.org)
+-- Forum: Lindenis V5 (http://forum.lindeni.org/forumdisplay.php?fid=5)
+--- Forum: General Discussion on Lindenis V5 (http://forum.lindeni.org/forumdisplay.php?fid=6)
+--- Thread: Questions about boot modes on Lindenis V5 (/showthread.php?tid=7148)
Questions about boot modes on Lindenis V5 - DWD - 08-28-2019
Hello,
I currently have two Lindenis V5 boards and I want to understand the boot process a little bit more.
From Allwinner documentation, I understand that there’s so called FEL pin which either boots motherboard normally (depending on BOOTSEL flags) or enters UPGRADE mode (USB or UART).
So can you please help me with the following questions:
- Where this FEL pin is located? I can’t find it in schematics.
- How to enter UART upgrade process instead of USB? I want to try it out.
Недвижимость - DamaPed - 09-19-2019
http://irkut-invest.ru
купить новостройку от застройщика|
новостройки в районе|
новостройки 2019|
новостройки от застройщика недорого|
новостройка 1|
http://priorestate.ru
ремонт квартир под новостройках|
квартира в новостройке от застройщика|
квартира ключ новостройка|
новостройка планировки и цены от застройщика|
квартира под ключ в новостройке|
RE: Questions about boot modes on Lindenis V5 - itzandroidtab - 09-27-2019
I found some information about the firmware upgrade mode.
On the emmc flash page they have a picture what pins to connect to enable firmware upgrade mode:
on this page: http://wiki.lindeni.org/index.php/Writing_an_image_to_the_eMMC
this picture: http://wiki.lindeni.org/index.php/File:Lindenis-v5-uboot-test-point.jpg
And if you go to the datasheet there is a note about uart/usb update pin:
http://files.lindeni.org/lindenis-v5/datasheets/lindenis-v5-schematic-v1.1.pdf
on page 4 the note says:
BOOT-SEL2: 0 USART_UPGRADE; 1 USB_UPGRADE
It looks like it is 1 by default so you need to connect the pin to gnd to enable usart upgrade mode. The pad the pin is connected to is called TP3 and is close to the pins for entering firmware upgrade mode. The precise location can be found on page 1 on this pdf:
http://files.lindeni.org/lindenis-v5/datasheets/lindenis-v5-place-map.pdf
All these pdf can be found at the bottom of this page
http://wiki.lindeni.org/index.php/Lindenis_V5#Datasheet
RE: Questions about boot modes on Lindenis V5 - DWD - 10-22-2019
Hey, thanks for the information!
Sorry for the late response, I am currently trying to make new camera work and UART boot can wait, it's not really important.
I'll make a new topic.