How to properly set up ov2718 camera module?

[DWD]

my ov2718 datasheet has version 2.03, july 2001 year ))) 18 year old!  and datasheet describe 2720 sensor! not 2718 ))

Wait, are you suggesting that driver in Lindenis kernel named ov2718_mipi.c is actually a driver for ov2710 sensor?

What the pixel rate are you setup? (which registers used for this?) table rate for ov2718

First, the table you linked is for ov2720 sensor.
About pixel rate and registers, I am currently researching this topic... I honestly thought that driver would work out of the box, because you know, the name "ov2718_mipi" suggests it should work with ov2718 camera I will provide more info on this later.

What the input clock frequency (for ov2718) are you setup in clk-sun8iw12.c file or sys_config.fex?

This is interesting, can you elaborate on it a bit more? Where in fex should I specify the input clock? I found this section:

Code:

[clock]
pll4            = 300
pll6            = 600
pll8            = 360
pll9            = 297
pll10           = 264

Is this it? I didn't specify anything in clk-sun8iw12.c.

The improper clock/frequency setup might be the case.
Thanks, you gave me some ideas where to look. I'll check ov2718 manual and will be back when I get additional information.